I did try using the driver as described – no success. I just says the driver is pre-installed. But then if I connect the uRadMonitor device there is still only the non-functioning COM1 Port.

Any other ideas?

I did find a way – if anyone will want to know please tell me.

Now the question is how I would design the API call to get the most recent values?

The unit always connects without a problem if I unplug an replug the power supply.

Could it be possible to setup a watchdog timer in the software to reboot the unit upon loss of WiFi signal or do a daily restart?

The new industrial unit is up and running – perfect.

May I also ask you to switch off the system beep for this unit, too (14000013).

Thank you

It would be both units 82000075 and 82000071

I found the local IP – so in theory I can access data local. In theory only since, as I haven read in some other posts, some of the values are post-processed on the website.

If I understand correctly we only got limited amounts of API-accesses. This is regrettable since it does reduce the resolution of graphing solutions (i.E. Cacti/RRDtools) considerably.