Forum Replies Created

Log In Register Lost Password
Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • October 22, 2020 at 8:32 pm in reply to: A3’s and Smoggie’s online data not showing even though connected #28542
    Paul Probett
    Participant

    Hi Wolferl,

    All sorted thanks. It appears that because we had clicked on the option to make the units “Hidden”, this was hindering us from accessing the graph data online, even though the units were active and recording. However, we have unselected the “Hidden” option and instead are using the “Randomize” feature. This maintains our clients privacy while still allowing us to obtain the online data.

    Thanks to Radu for answering our email in a timely manner!

    October 21, 2020 at 9:20 pm in reply to: A3’s and Smoggie’s online data not showing even though connected #28540
    Paul Probett
    Participant

    However, the stock communial monitor based in Romania has it’s “Detailed” data graphs available online, where as all of our ones do not.

    September 3, 2020 at 9:33 pm in reply to: A3 Ozone flat line (almost) #28512
    Paul Probett
    Participant

    Hi there,

    Just wondering. In New Zealand, our workplace standards have a Ceiling Limit of 0.1ppm (100ppb) for Ozone. Both NIOSH and OSHA in the USA also have limits of 0.1ppm for Ozone.

    Does this mean that the sensors used in the A3 are not really of much use for detecting compliance with these standards due to the detection range being 200ppb-10ppm, unless the Ozone is over 200ppb?

  • Author
    Posts
Log In Register Lost Password
Viewing 3 posts - 1 through 3 (of 3 total)