Forum Replies Created

Log In Register Lost Password
Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • January 31, 2020 at 5:24 pm in reply to: 3D Printable Solar Radition Shield & Vents #6971
    Cristian
    Participant

    Once again, thank you Rod !!
    I can`t believe I have not seen the dimensions although I have checked the data sheets few times (guess time has come for spectacles :-))

    Based on the datasheet specs, Industrial and A3 Wi-Fi share the same dimensions (110x65x25mm – apparently based on your measurements, these dimensions are without the protection case). I am planning to install it inside the shield with the case on so I am going to try out your large version of shield.

    BR

    January 31, 2020 at 3:01 pm in reply to: 3D Printable Solar Radition Shield & Vents #6965
    Cristian
    Participant

    Thanks Rod for the 3d shield design, looks good in that pic !

    Now, I am trying to figure out if I can fit an A3 inside this solar radiation shield but unfortunately I cannot find sizes for either of the sensors, Industrial and A3 wi-fi to compare.
    Anyone, any clue ?

    BR

  • Author
    Posts
Log In Register Lost Password
Viewing 2 posts - 1 through 2 (of 2 total)