Firmware successfully Updated o/

uRADMonitor 120000xx
type:1 hw:108 sw:110 SI-29BG

I have been super extra careful to test, test and retest the polarity of the USBAsp connector before connecting the dongle to my computer, as I really didn’t to fry anything (and the Chinese spin-off can’t really be trusted to be the same way than the one pictured in the documentation). I made sure that the ground goes from the USB connector up to the uRADMonitor Board, Then connected the USBAsp, installed the driver, launched a cmd as Administrator and launched the flash procedure. All went well, and I can now read the values directly from the HTTP running on the device.

Thank you a lot Radhoo