Home › Forum › Accessories › 3D Printable Solar Radition Shield & Vents

Log In Register Lost Password
Viewing 5 posts - 1 through 5 (of 5 total)
  • Author
    Posts
  • June 8, 2019 at 7:47 am #6570
    Rod
    Participant

    Sorry, looks like the large version didn’t attach. Here is the file.

    Attachments:
    1. SRS_Large-v1.zip
    June 20, 2019 at 9:21 pm #6622
    Andrew Burwell
    Participant

    How does the antenna fit into the solar radiation shield? I just printed both the large and small sizes of this case but will need to modify it in order for the antenna to fit in. I was just wondering what you did, because I see in the picture you posted you have the same sensor I do. Awesome design and thanks for the help!

    January 31, 2020 at 3:01 pm #6965
    Cristian
    Participant

    Thanks Rod for the 3d shield design, looks good in that pic !

    Now, I am trying to figure out if I can fit an A3 inside this solar radiation shield but unfortunately I cannot find sizes for either of the sensors, Industrial and A3 wi-fi to compare.
    Anyone, any clue ?

    BR

    January 31, 2020 at 4:40 pm #6970
    Rod
    Participant

    Hay Cristian, i have only ever had Industrial units from Radu, the dimensions of the enclosure are as follows

    147mm length
    41mm deep
    58mm width

    On the width you do need to allow an extra 17mm for the BME & Microphone sensor

    You will see what i mean if you look at this tech document – https://www.uradmonitor.com/wordpress/wp-content/uploads/2020/01/industrial_datasheet_106.pdf

    Please also note the overall length also included the mounting tabs at each end which are 15mm long each end

    January 31, 2020 at 5:24 pm #6971
    Cristian
    Participant

    Once again, thank you Rod !!
    I can`t believe I have not seen the dimensions although I have checked the data sheets few times (guess time has come for spectacles :-))

    Based on the datasheet specs, Industrial and A3 Wi-Fi share the same dimensions (110x65x25mm – apparently based on your measurements, these dimensions are without the protection case). I am planning to install it inside the shield with the case on so I am going to try out your large version of shield.

    BR

  • Author
    Posts
Log In Register Lost Password
Viewing 5 posts - 1 through 5 (of 5 total)
  • You must be logged in to reply to this topic.