- This topic has 3 replies, 3 voices, and was last updated 7 years, 7 months ago by
.
Viewing 4 posts - 1 through 4 (of 4 total)
Viewing 4 posts - 1 through 4 (of 4 total)
- You must be logged in to reply to this topic.
uRADMonitor.
sfdugganis there and plan to make a unit that run on POE it would make deployment a lot simpler i find power the limiting factor as to where i can place mine.
uRADMonitorPlease use a Passive POE cable. Many uRADMonitor users are having good results with them.
The A3 units also support a wide voltage input (6V to 28V, but not more than 28.00V!! ), so you can use a higher voltage (eg. 24V) and not care about the length of your cable.
See:
https://www.facebook.com/193197037509636/photos/?tab=album&album_id=398902893605715
or
https://www.ebay.com/sch/i.html?_from=R40&_trksid=m570.l1313&_nkw=passive+poe+cable&_sacat=0
Scott McInnessYou can also try any of the 48V to 12V 802.3af/at adapters on eBay – such as those found here: https://www.ebay.com.au/sch/m.html?_ssn=horizon_electronic&_nkw=poe+12v You’ll need one with a 5.5×2.1mm barrel jack.
This one gives you drop-downs for voltage and plug and the description says 5.5×2.1mm: https://www.ebay.com.au/itm/282213516881 Not my ad, no connection to seller, etc.
I’ve used a similar one on my old Model A for years and will likely use one very soon for my A3, when I find somewhere at work that I can put it.
uRADMonitorWould a built in POE still be needed given these excellent alternative solutions?