Home › Forum › Hardware › DIY KIT1 v102 – Unit voltage on GM tube is too low › Reply To: DIY KIT1 v102 – Unit voltage on GM tube is too low

June 19, 2016 at 7:33 pm #3047
uRADMonitor
Keymaster

I’ve seen this before, and the problem was related to the inductor. Try getting 2.2mH inductors from a different source, or ,as a quick dirty hack, put two 2.2mH inductors of the kind you have now in parallel.

We might get over this by changing the frequency the inverter operates at – drop me a mail so I can send you a test firmware that uses a lower frequency (that might get noisy).